Morphy Richards Carpet Cleaner - Manual (Page 4)

Operation
Please remember that the steam cleaner
operates by emitting steam at an increased
temperature of 115˚C. Never use it on
objects or surfaces which cannot resist this
temperature, delicate materials, dralon,
plastic, natural fur etc. Where any doubt
exists check carefully on a part of the
material where minor marks will not matter.
Filling the water tank
1 To fill, unscrew the filler cap ‹ anti-
clockwise. B
2 Fill the boiler with a maximum of 1 litre
of water by using the funnel and the filler
jug provided
C.
Three full jugs make up the 1 litre
required. WARNING: Do not overfill.
• Do not use any detergent.
3 WARNING: Screw the filler cap
clockwise to tighten. Tighten fully.
Heater switch
1 When the water tank has been filled,
insert the plug into the power socket.
2 Fit the required nozzle/accessory.
3 Switch the cleaner on by pressing the
heater switch ⁄ to the on position. D
The boiler will take approximately 5
minutes to heat up.
WARNING: As soon as the boiler is
up to temperature steam will begin to
be emitted from the nozzle. Hold the
nozzle away from the body and away
from other persons.
• Water may be ejected at first. Aim the
nozzle into a sink or bucket.
WARNING: Do not block the end of
the nozzle. If the nozzle becomes
blocked a safety relief valve releases
steam pressure from the base of the
filler cap.
Note: the ‘heater on’ light will cycle on
and off during use, this is normal.
Note: If the product is switched off
before the boiler is empty, steam will
continue to be emitted for up to 2
minutes. You can continue to use the
steam to clean or rest the hose in a
sink until the steam has dispersed.
Refilling
When the steam flow begins to slow the
unit is ready for refilling.
1 Switch off the cleaner before refilling.
2 Unplug from the mains socket and leave
for a few minutes to cool.
WARNING: Allow any steam to
disperse away before attempting to
remove the filler cap.
3 Carefully unscrew the cap.
WARNING: Take care as the inner
part of the cap will be hot.
4 Use warm water to reduce heat-up time.
Refill using the funnel and the jug.
• The water tank should be emptied after
use. Allow to cool completely before
emptying.
4
B
C D
70450 Rev 2 22/2/05 9:48 AM Page 4