Marantz MAR0076 - Manual (Page 4)

&
Place the receiver box wherever you want, but leave at least 5 cm space
free all around the box for ventilation and do not cover the ventilation
openings, (e.g. on the ground, in a cupboard, behind a wall, in another
room....). To prevent any unsafe situations, do not place any objects on
top of the monitor or the receiver. No naked flame sources, such as
lighted candles, shoud be placed on or in the vicinity. Avoid heat,
direct sunlight and exposure to rain or water. The equipment shall
not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, shall be placed on it.
é
Connect the supplied aerial cable 1 and the VGA cable 2 as shown
in the inside frontcover of this handbook. Make sure all screws of the
cable 2 are tightened well. Connect audio cinch connectors to the
“constant level out” on the receiver box 3 and to your audio amplifier
or receiver. See also page 20.
“
To connect your computer, see p. 22.
To connect other peripherals, see p. 20.
In order to obtain the best result, please use only the supplied antenna
cables between the receiver box and videorecorder, and between
videorecorder and antenna connector.
‘
Insert the mains cord supplied 4 (with filter) into the MAINS INLET at
the back of the monitor and the mains cord 5 at the back of the
receiver. Put both in the wall sockets.
Please, only use the mains cord 4 (with filter) supplied with the
monitor, for the monitor and the mains cord 5 supplied with the
receiver, only for the receiver.
(
Remote control:
a Slide the battery door off the back of the Remote Control.
b Remove the plastic AA battery tray from the battery compartment
c
Insert the battery pack (included with the recharging dock)
as indicated on the side of the battery pack.
d Slide the battery door back on.
After a few seconds, the Remote Control starts up automatically and
beeps twice to indicate that it has finished starting up.
e Plug the power adapter into a wallet outlet and connect it to the
recharging dock.
f Place the Remote Control on the recharging dock.
Recharging starts automatically. The light on the front of the
recharging dock indicates charging takes place. When the battery
pack is fully charged, the light goes off.
§
Switch the TV on : Press the power button A at the front of the
monitor and the one on the front of the receiver box.
A green indicator lights up and the screen comes on.
If the indicator is red, press the channel +/- key on the remote
control.
The green indicator blinks every time you press a key on the remote
control. When you switch on your set for the first time, the menu
LANGUAGE automatically appears on the screen. The explanation
appears in different languages one at a time.
1-3
Preparation
Preparation
A
English