Multi-Tech Systems MultiConnect Adapter - Manual (Page 13)

Chapter 5 – Setting Country or Region Codes Using the CLI
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354B) 13
Chapter 5 – Setting Country or
Region Codes Using the CLI
The Default Country or Region Code is B5.
If You Want to Change the Country or Region Code, Use the Command Line Interface:
Command Syntax set serial s1 modem country-code value <value>
Description Sets the modem country/region code value to <value>.
This command is valid only for port s1. Applicable only if the country-code type is set
to code.
Default Value -
Success OK
Error 1. Too few arguments
“Usage: set serial s1 modem country-code value <value>
Type ‘set serial s1 modem country-code value ?’ for more information”
Note: There is no validation on the country/region code value.
To View Country or Region Code:
Command Syntax show serial modem country code
This command is supported on s1 only.
Description Displays the supported country/region codes for this product.
Default Value -
Success OK
Error 1. Too few arguments
Possible value(s) are
configuration
chat-script
country/region code
modem-configuration
statistics
Country or Region Codes – A list of thcountry or region code settings for the countries/regions that Multi-
Tech currently supports is available on the Multi-Tech Web site at:
http://www.multitech.com/PRODUCTS/Categories/External_Device_Networking/global_modems/configuration.asp
#chart