MACKIE S408 - Manual (Page 9)

9
S408 SPECIFICATIONS
Acoustic Performance
Frequency Range (–10 dB)
60 Hz– kHz
Frequency Response (–3 dB)
80 Hz–18 kHz
Horizonal Coverage Angle (–6 dB)
75º averaged  kHz to 10 kHz
Vertical Coverage Angle (–6 dB)
40º averaged  kHz to 10 kHz
Sensitivity 99 dB @ 1W/1m
Max SPL long-term 17 dB @ 1m
Max SPL peak 10 dB @ 1m
Crossover Point 500 Hz
Input/Output
Input/Thru Type Neutrik Speakon™
Input Impedance 8 ohms
Power Handling 600 watts rms continuous
400 watts peak
High-Frequency Section
Voice Coil Diameter 1.75 in/44 mm
Horn Exit Diameter 1.0 in/5 mm
Phase Plug Optimized geometry
Diaphragm Material Titanium
Magnet Material Ferrite
Low-Frequency Section
Woofer Diameter 8.0 in/0 mm
Voice Coil Diameter .0 in/51 mm
Diaphragm Material Paper
Magnet Material Ferrite
Construction Features
Basic Design Trapezoidal, 7.5º side angles
Material 18 mm multi-layered plywood,
resin end caps
Finish Wear-resistant textured black
PVC vinyl
Handles One on each side, one on top
Grille Perforated metal with weather-
resistant coating
Physical Properties
Height 1.9 in/81.0 cm
Width 0.1 in/51. cm
Depth 17.9 in/45.5 cm
Weight 7 lb/.7 kg
Mounting Methods
Integrated mounting points, /8" inserts.
Two each located on each side and rear of
enclosure, three each located on top and bottom.
Use /8"–16 x " forged shoulder eye bolts.
Consult a professional rigger or structural
engineer prior to suspending the S408 enclosure.
Never attempt to suspend the cabinet by its
handles. The S408 is also pole-mountable via
the built-in socket on the bottom of the cabinet.
Be sure the pole is capable of supporting the
weight of the S408 cabinet.
Disclaimer
Since we are always striving to make our products better by in-
corporating new and improved materials, components, and manufac-
turing methods, we reserve the right to change these specifications
at any time without notice.
“Mackie” and the “Running Man” figure are registered trademarks
of LOUD Technologies Inc.
All other brand names mentioned are trademarks or registered
trademarks of their respective holders, and are hereby acknowledged.
©005-006 LOUD Technologies Inc.
All Rights Reserved.
CARE AND MAINTENANCE
Your Mackie loudspeakers will provide many years of
reliable service if you follow these guidelines:
Avoid exposing the loudspeakers to
moisture. If they are set up outdoors,
be sure they are under cover if you
expect rain.
Need Help?
You can reach a technical support representative
Monday through Friday
from 7 AM to 5 PM PST at:
1-800-898-3211
After hours, visit www.mackie.com and click Support,
or email us at: [email protected]
• Avoid exposure to extreme cold (below freezing
temperatures). If you must operate the loud-
speakers in a cold environment, warm up the voice
coils slowly by sending a low-level signal through
them for about 15 minutes prior to high-power
operation.
• Use a slighty damp cloth with a mild soap solution
to clean the cabinets. Only do this when the power
is turned off. Avoid getting moisture into any of the
openings of the cabinet, particularly where the driv-
ers are located.