MartinLogan E2 User Manual
Page 9
Advertising
Assembly 9
12 Install woofer wiring harness as shown. You can move the
tower to the preferred listening position by shifting
the unit from side to side and “walking” it.
13 When you are confident the sub tower is correctly
positioned, mark the floor with masking tape at each
corner. Install the spikes by using a safe dolly to tip the
sub tower back, remove the glides, and then screw the
spikes into place. Make sure you thread the large
black rubber washer onto the spike post before
installing in the tower. Place the tower in a vertical
position, and level front to back by tilting the tower
back (at least 3 people are required) and adjusting the
spikes.
Figure 13
Figure 14
Advertising