Madrigal Imaging N38 - Manual (Page 17)

17
Set-up and Installation
The Nº38 incorporates both RCA-type and XLR-type connectors for
audio signal input and output.
The Madrigal-designed RCA-type connectors used for single-ended
audio interconnection are a great improvement over ordinary RCA-
type connectors, offering superior contact integrity and mechanical
locking when used in conjunction with the Madrigal cable-mounted
RCAs. The gold-plated XLR-type connectors used for balanced
connections are of Swiss design, and are made to professional
application standards.
When connecting the Nº38 to source equipment and power
amplifiers, we recommend Madrigal Audio Laboratories HPC
Interconnect Cable. HPC is available in various lengths, terminated
with RCA, XLR, or Camac connectors. See your Mark Levinson dealer
for more information.
Connect the AC cord to the male IEC connector on the center of the
bottom panel of the Nº38, then connect the AC cord to the AC mains.
To Nº38 To AC mains
1
3
2 1 2
3
1 = Line (hot)
2 = Neutral
3 = Earth ground
When power is first applied to the Nº38, it will run through an automatic
initialization sequence which (among other things) provides a “role-
call” of the current input aliases (see “Aliases” on the next page),
selects the first alias
other than NOT USED or ssp, and sets the volume
to OFF.
For optimal sonic performance and longevity, the Nº38 is designed to
remain powered at all times (the Standby switch merely mutes the
preamplifier’s outputs and turns off the display). There is an initial
break-in period of 300 hours before the Nº38 achieves optimum
performance.
Note: If AC mains power to the Nº38 is interrupted, the main
output will be muted. When power is restored, the initialization
sequence described above will restore the preamplifier to
normal operation, with the main output muted and the Display
indicating OFF. We recommend you allow the circuitry within
your various system components to stabilize for 1 to 2 minutes
before use after such a power outage.
AC power cord polarity
Power connection and
system activation
Connections and cables