Miller Electric Elitet - Manual (Page 10)

OM-217 741 Page 8
SECTION 5 − REPLACING THE LENS COVERS
Ref. 804 109
Y Never use the auto-dark-
ening lens without the in-
side and outside lens
covers properly installed.
Welding spatter will dam-
age the auto-darkening
lens and void the
warranty.
1 Front Lens Gasket
2 Outside Lens Cover
3 Lens Assembly
4 Inside Lens Cover
5 Lens Frame
Remove the lens assembly to
remove either lens cover.
To remove the lens assembly,
push down on the helmet bot-
tom retaining arms and push the
retaining clips toward the out-
side of the helmet. Lift up on the
assembly and pull free of the
helmet.
Outside Lens Cover
Remove the outside lens cover
by pushing into the helmet. Re-
move the rubber lens gasket
and install on the new lens cov-
er. Reinstall the lens assembly.
.
Be sure the flat side of lens
cover gasket faces the lens
cover holder.
Inside Lens Cover
To replace the inside lens cover,
remove the lens assembly from
the lens frame by pushing up on
the top two retaining tabs while
gently pushing the lens free.
Remove the lens cover by slid-
ing it out of either side. Replace
with the new cover lens and re-
install the assembly in the
helmet.
4
3
2
1
5
Be sure flat side of gasket
faces lens cover holder.