Master Bilt BSD Series User Manual

Bsd series refrigerators and freezers

Advertising
background image

1

4/07

BSD SERIES

REFRIGERATORS AND FREEZERS

Installation, Operation and

Maintenance Instructions


INSPECTION

When the equipment is received, all items should be carefully checked against the bill of
lading to insure all crates and cartons have been received. All units should be inspected for
concealed damage by uncrating the units immediately. If any damage is found, it should be
reported to the carrier at once, and a claim should be filed with the carrier. This equipment
has been inspected and tested at the manufacturing facility and has been crated in
accordance with transportation rules and guidelines. Manufacturer is not responsible for
freight loss or damage.

INSTALLATION

GENERAL

If casters are installed, care should be taken when removing the unit from the crate base.
The unit is heavy and can present a hazard if not handled with care. Remove the unit crate
and crate base. Discard hardware used to secure the cabinet to the crate base. Ensure that
at least two persons are available to install the casters. Lay the cabinet on its back to
create access to the cabinet bottom. Attach the casters to the cabinet base suing the
factory installed screws as shown below.
Remove the ¼ x 20 x ¾ screws (4 per
caster) that are factory installed. Position the
caster and reinstall. Ensure that the locking
casters are installed on the front of the
cabinet. After installation is complete, return
the cabinet to its upright position. The
cabinet should set in the upright position for
at least one hour prior to energizing. This is
required to allow the refrigeration to settle to
its normal state. The cabinet should also be
levelled when it is placed in its permanent
location.

Advertising