Muratec F-150 - Manual (Page 81)

Beyond the basics
Dialing from the numeric keypad while using the PIN mask
Note: If the PIN mask feature is off, you dial normally.
If you’ve specified Mode 1 — use “star” power
1 Enter the phone number, then press the * (“star”) key and enter the PIN .
The PIN always goes last. For example, to dial 19725550911 with a PIN of
“123456”, enter 19725550911*123456:
2 Press START . The PIN disappears from the display, and your machine dials the
desired phone number.
If you’ve specified Mode 2 — the machine guides you
1 Enter the phone number as usual.
2 Press START . The LCD now shows:
3 Use the numeric keypad to enter the PIN .
4 Press START . Your machine will dial the number.
Performing batch transmission while using the PIN mask
Note: The following instructions presume you are familiar with how to set and use
both your machine’s autodialer and its batch transmission feature. If you
need to review, see pages 2.8–2.16 for more on the autodialer and/or pages
2.24–2.27 for more on batch transmission.
Note: If the PIN mask feature is off, you dial normally.
If you’ve specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include
the PIN . (To review how to include this information in an autodialer
number, review the Mode 1 instructions under “Autodialing while
using the
PIN mask,” page 2.50.)
Before sending a batch transmission to a desired number the first time, you must
store the
PIN within its batch box. Here’s how:
1 Perform the batch box setting until you’ve entered the batch box number.
The
LCD now asks for the fax number (here, we’re working with batch box 1):
2 Enter an autodialer number, or use the numeric keypad to enter the fax num-
ber, to which the batch transmission should go.
Important: If you’re using an autodialer number, it must contain the PIN , as
mentioned previously.
If you’re entering a number from the numeric keypad, enter the
fax number, followed by the * (“star”) key and then the
PIN .
3 Press ENTER to save the setting.
Note: If you press ENTER without entering the PIN , the fax machine beeps,
indicates “No PIN Number” on the LCD and then returns you to step 2.
Now you can perform batch transmission to this box while the PIN mask is activated.
1:Fax Number
_
Enter PIN Number
123456_
Enter PIN Number
_
Press Start
19725550911_
Press Start
19725550911*123456
2.52