Maxtor D540X-4K - Manual (Page 29)

Installation
Maxtor D540X-4K 20.4/40.0/60.0/80.0 GB AT 3-11
 %NGCTCPEG
Clearance from the drive to any other surface (except mounting surfaces) must be a
minimum of 1.25 mm (0.05 inches).
 8GPVKNCVKQP
The Maxtor D540X-4K 20.4/40.0/60.0/80.0 GB AT hard disk drives operate
without a cooling fan, provided the ambient air temperature does not exceed 131
°
F
(55
°
C) at any point along the drive form factor envelope.
 %1/$+0#6+10 %100'%614 ,
J1 is a three-in-one combination connector. The drive’s DC power can be applied
to section A. The ATA bus interface (40-pin) uses section C. The connector is
mounted on the back edge of the printed-circuit board (PCB), as shown in Figure
3-9.
(KIWTG   J1 DC Power and ATA Bus Combination Connector