Philips Magnavox 27MS3404R - Manual (Page 7)

7
ANT 75‰
L/Mono Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
1
T he Cable TV input into your home may be a
single (75 ohm) cable. If so, this connection is
very simple. Follow the steps below to connect
your cable signal to your new television.
Direct Cable Connections:
1 Connect the open end of the round
Cable Company supplied cable to
the 75
Ω input on the TV. Screw it
down finger tight.
B
ASIC
C
ABLE
TV C
ONNECTION
Back of TV
Direct Cable Connection:
Cable signal coming
from Cable
Company (Round
75 Ω coaxial cable)
Jack Panel Back of TV
A combination antenna receives normal broad-
cast channels (VHF 2–13 and UHF 14–69).
Your connection is easy because there is only one
75
Ω (ohm) antenna plug on the back of your
TV, and that’s where the antenna goes.
1 If your antenna has a round cable
(75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has a flat, twin-
lead wire (300 ohm), you first need
to attach the antenna wires to the
screws on a 300- to 75-ohm adapter.
2 Push the round end of the adapter
(or antenna) onto the 75 Ω (ohm) plug
on the back of the TV. If the round
end of the antenna wire is threaded,
screw it down finger tight.
B
ASIC
A
NTENNA
C
ONNECTION
After using the AutoProgram Control, press
the CH + and – buttons to scroll through all
the channels stored in the television’s memory.
H ELPFUL H INT
1
2
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
Back of TV
Round 75 Ω
Coaxial Cable
from Antenna
Twin
Lead Wire
300 to 75-ohm
Adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
Antenna Connection:
Jack Panel
Back of TV