Figure 6-12 – Motorola PR400 User Manual
Page 60

July, 2004
6881096C24-A
6-10
Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
4.
Locate the speaker tab and align it with the tab opening in the front housing (
).
5.
Insert the speaker tab into the speaker recess in the housing. Ensure the speaker is seated flush
in the housing.
6.
Insert one end of the speaker retainer into the slot in the front housing (See
7.
Install the retainer screw using a T6 Torx screwdriver. Torque to 2.3 - 2.5 lb/in.
Figure 6-12. Microphone Re-assembly
Note: Make sure the speaker and microphone wires are routed tightly between the speaker bas-
ket and the housing post.
Figure 6-13. Speaker Re-assembly
Note:
When fastening the speaker retainer screw, make sure the wires are out of the way to pre-
vent pinching by the retainer.
Microphone
Boot
Microphone Recess
Microphone Position
Speaker Retainer
Speaker
Front Housing Slot
Tab Opening
Speaker Tab