Marantz CC9100 - Manual (Page 7)

6
EXTERNAL INTERNAL OUT IN
REMOTE CONTROL DIGITAL OUT OPTICAL LINE OUT L R
EXTERNAL
INTERNAL
R L
C D REMOTE
CONTROL
DIGITAL
OPTICAL IN
IN
OUT L R
L R
CONNECTIONS
Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.
A Making connections
z Connect the LINE OUT jacks of this unit to the input jacks (CD
or AUX) of the amplifier. Make sure that the white plugs are
connected to the left (L) jacks and the red plugs to the right (R)
jacks.
• Be sure not to connect this unit to the amplifier’s PHONO jacks,
as sound will be distorted and normal playback will not be
possible.
x Connect the power cord to a household AC wall outlet.
• Make sure plugs are inserted fully into the wall outlet.
Note!!
If you connect the power cord to a “SWITCHED” AC outlet on an
amplifier, you will not be able to use this unit's memory function.
B Connecting the OPTICAL FIBER CABLE
CD can be played using the digital output.
This unit can be connected to an amplifier equipped with an
optical digital jack.
1. Remove the protective dust cap from this unit’s
OPTICAL
DIGITAL OUT jack.
2. Use an optical fiber cable to connect the OPTICAL DIGITAL
OUT jack of this unit to the optical input jack of the amplifier.
• Align the plug of the optical fiber cable with the optical digital
jack and fully insert the plug to make a secure connection.
Use a separately sold optical fiber cable for the optical digital jack
connections.
To another
MARANTZ audio
component with a
remote sensor.
C-x
Power cord
A-x
D-BUS remote
control cable
C-z
CC9100
AV surround receiver
Optical
fiber
cable A-z
B
Audio cable
Normal conections
White Red
White Red
C System Control Connections
By connecting this CD changer to another MARANTZ audio
component using a D-BUS remote control cable, you can operate
the components remotely as a single system.
z When connecting to a component with a remote sensor,
connect the
REMOTE CONTROL IN jack of this unit to the
REMOTE CONTROL OUT jack of the component with the
remote sensor.
• When connecting to a component which is not equipped with a
remote sensor, connect the component to the
REMOTE
CONTROL OUT jack of this unit.
x When using this unit independently, set INTERNAL/EXTERNAL
switch to INTERNAL . When using this unit in a system
incorporating a MARANTZ AV surround receiver, tuner or timer
equipped with a remote sensor, set the switch to
EXTERNAL .
Note!!
Always set this switch to INTERNAL unless the unit is connected
to other MARANTZ equipment with the REMOTE CONTROL IN/
OUT jacks. When this switch is set to EXTERNAL , the unit’s
remote sensor window is disabled.
INTERNAL/
EXTERNAL
switch
C-x