MTD 31AE993I401 User Manual
Page 17
17
.
Figure 24
•
Secure with the bell washer and hex bolt removed
earlier.
•
Secure the frame cover with six self-tapping
screws. Put the snow thrower down to its normal
operating position.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
SECTION 8: OFF-SEASON STORAGE
•
If unit is to be stored over 30 days, prepare engine
for storage as instructed in the engine manual.
•
Remove all debris from the exterior of equipment.
•
Follow lubrication recommendations on page 12.
•
Always store the snow thrower in a clean, dry area.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
Safety & Decorative Labels: Part Number and Location
Shift Arm
Assembly
Pin
Friction
Wheel
Sprocket
Spacer
Sprocket
Hex Hub
of Sprocket
Hex
Shaft
Spacer
WARNING:
Never store engine with fuel in
tank indoors or in poorly ventilated areas,
where fuel fumes may reach an open flame,
spark or pilot light as on a furnace, water
heater, clothes dryer or other gas appliance.