Memorex MPH6928 - Manual (Page 28)

To change your Caller ID options:
1) Press and hold
CALLER ID
for two
seconds. The following screen appears.
2) Use the : and ; keys to move the cursor to the selection that you
would like to change. Press the
SELECT
key to toggle between
On
and
Off
for
Autotalk
and
CIDCW
. Press
SELECT
and use the number
keypad to enter or change the area code, then press
SELECT
again. (You hear
a confirmation tone indicating the area code has been changed.)
3) After you have made your selections, press
CALLER ID
and return the
handset to the base. The
STATUS
LED flashes, indicating that your
setup changes are now effective.
▼
Screening Your Calls
Caller ID allows you to review caller
information before you answer your
phone. When the phone rings, the
display shows the date, time, name, and
phone number of the caller. If your Caller ID
service is number only, then the name does
not appear on the second line.
If a name or number is not available, the display will show a
message such as
Incomplete Data
,
Private Number
,
Private Name
, etc.
▼
Using CIDCW (Caller ID on Call Waiting)
1) During a call when you hear the
Caller Waiting tone, check the handset
for the name and number of the
incoming caller.
2) Press
FLASH
to accept the incoming call. See page 22 for
additional information.
27
NOTE
If you have no New Caller ID
Messages, then the “New”
display is blank. Only the
“Total” display appears.
NOTE
Once a Caller ID message
has been viewed, it is no
longer considered a
new message.
HINT
You may use the < and >
keys to toggle between
numbers when programming
the area code.
1 > Auto Talk:Off
2 CIDCW :On
3 Area Code:
12/21 12:30PM
Schlitz Kaysie
305-555-1212
Talk 0:00
Schlitz Kaysie
305-555-1212
C:...MPH6928 VA OM.vp
Mon Feb 14 15:27:45 2000
Color profile: Disabled
Composite Default screen