Multiquip Mikasa Reversible Plate Compactor MVH-402DSB - Manual (Page 18)

PAGE 18 — MQ-MIKASA MVH-402DSB PLATE COMPACTOR — PARTS & OPERATION MANUAL — REV. #2 (03/30/05)
Recoil Start
1. Open the fuel cock (Figure 8).
2. Move the throttle lever to the START position by opening
it to about 20 degrees (Figure 9).
3. Grasp the starter grip (Figure 11) and slowly pull it
out. The resistance becomes the hardest at a certain
position, corresponding to the compression point.
Pull the starter grip briskly and smoothly for starting.
4. Push down decompression lever (Figure 12) and
release.
5. If the engine does not start, repeat steps 4 and 5.
Figure 12. Decompression Lever
Figure 11. Engine Start Handle
MVH-402DSB—OPERATION
TRAVELING
Make sure to follow all safety rules referenced in the
safety section of this manual before operating com-
pactor. Keep work area clear of debris and other
objects that could cause damage to the compactor
or bodily injury.
CAUTION
1. Grasp the compactor's hand grip (Figure 13), and move the
engine throttle lever (Figure 13) quickly to the fast position.
2. With the throttle lever in the fast position, the engine speed
should be around 2,300 RPM, therefore engaging the cen-
trifugal clutch.
Figure 13. Throttle Lever ((Fast)
ALWAYS move the throttle lever
quickly without hesitation, because
increasing the engine speed slowly
causes the clutch to slip.
NOTE
3. To make the compactor move in the forward direction push
the travel lever ( Figure 14) forward.
Figure 14. Direction Lever