Madrigal Imaging MP-8 - Manual (Page 54)

Example 2
A single signal switcher is connected to the projector and a computer
is connected to slot 3 of the switcher. To display the computer output,
press
.
Note: If a switcher is connected to the projector, its inputs can be selected using
the switcher’s front panel push buttons.
Direct Channel
➤
Selection
This method of source selection takes advantage of the Channel List feature
explained in section 3.7, Utility Features. The Channel List allows you to
assign a source to a 2-digit number, from 01 to 99.
Once you have assigned channel numbers to your sources, and the projector
is at operation level, you can select a source by pressing the 2-digit channel
number associated with it.
To select a channel, press .
where: m = the 1 st digit of the channel number
n = the 2 nd digit of the channel number
n m
SOURCE
INPUT
Switcher Number 1
The computer output
is connected to slot 3
of switcher number 1.
The switcher output
is connected to
slot 1 of the projector.
ON/OFF STANDBY PROJECTOR
ELECTROHOME MARQUEE SIGNAL SWITCHER
1 2 3 4 5 6 7 8 9
3 1 SOURCE
The workstation output
is connected to
slot 1 of the projector.
SOURCE
INPUT
OPERATION
3.12