Installing the wine chiller – Mabe Canada GWS04 User Manual

Page 4

Advertising
background image

Door Lock (available on some Models)

The key is located inside the plastic bag containing the Owner's Manual. Insert the key
in the lock and turn it counterclockwise to unlock the door. To lock the door do the
reverse operation. Remove the key and place in a secure location.

Interior Light (available on some Models)

You can turn the light ON or OFF by pushing the light switch located on the right side of
the control panel housing. If the interior light is left on, the temperature will be higher.

Installing the wine chiller.

4

Removing the Packaging

Before using the wine chiller, be sure all packing materials and tape have been removed,
including any protective film covering the control and any film protecting the cabinet.

If you are discarding an old refrigeration product, remove the doors to reduce the danger
of children being trapped inside.

The wine chiller must be freestanding.

Allow the following clearances for ease

of installation, proper air circulation
and electrical connections:

Each side

2" (51 mm)

Top

2" (51 mm)

Back

3" (51 mm)

Do not install the wine chiller where

the temperature will go below 55°F
(13°C) or above 90°F (32°C).

Install it on a level floor.

Do not install the wine chiller where it

will be subject to direct sunlight, heat
or moisture.

Do not store or install this appliance

outdoors.

The following models must be installed

on the floor: GWS04, GCS04.

Installation Guidelines

To raise the wine chiller

Adjustable legs at the front corners of the
wine chiller should be set so the wine
chiller is firmly positioned on the floor,
with a 1/8" (3 mm) tilt to the back to
help the door closure.

To adjust the leveling legs, turn the
legs clockwise to raise the wine chiller,
counterclockwise to lower it.

Leveling Legs

Consumer Support

Troubleshooting T

ips

Operating Instructions

Safety Instructions

Installation

Instructions

Care and Cleaning

Before connecting the appliance to the

power source, let it stand upright for
approximately 2 hours. This will reduce
the possibility of a malfunction in the
cooling system from handling during
transporation.

Loading the Wine

As with any refrigeration product, there is a slight temperature variance at different
locations within the cabinet. In this wine chiller, the lower shelves provide a slightly
cooler temperature than the upper shelves.

When storing both red and white wines, it is best to store the white wine on the lower
shelves where the temperature is slightly cooler.

Advertising