Mercedes-Benz 2005 C 230 Kompressor User Manual
Page 272
271
Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
̈
Switch on the ignition (
Step 2:
̈
If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons
2 and 4 and release
them only when the indicator lamp
1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.
Step 3:
̈
Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp
1 in view.
Step 4:
̈
Using both hands, simultaneously
press the hand-held transmitter
button
5 and the desired integrated
signal transmitter button (
2, 3
or
4). Do not release the buttons until
completing step 5.
The indicator lamp
1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
i
Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions:
(1) This device may not cause interfer-
ence, and
(2) this device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation of the device.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.
୴୴