Draft, Pci-1500 – Momentum Sales & Marketing Momentum Data Systems PCI-1500 User Manual
Page 2
17330 Brookhurst St., Suite 230, Fountain Valley, CA 92708
Phone: 714-378-5805 / Fax: 714-378-5985
email:
/ web URL:
http://www.mds.com
DRAFT
PCI-1500 :
: 266MHz Philips
NEXPERIA
PNX
1500
™
: 64MB DDR at 200MHz clock (400 MHz data rate)
: Philips SAA7118 PAL/NTSC/SECAM
• Four analog video inputs per ADC, four ADCs
• Features are programmable via I
2
C bus interface
: Philips SAA7105 Digital Video Encoder
• Three DACS, two times oversampled with 10-bit resolution
• Features are programmable via I
2
C bus interface
: TBD
• TBD
• Normal mode: Video decoder drives pixel clock into pnx1500, all other
clocks generated by pnx1500 internal PLL/DDS units
• Bypass mode: Video decoder drives pixel clock into pnx1500, video
encoder clock, and audio AD and D/A clocks
: pnx1500 with external PHY
• Full duplex support at both 10 and 100 Mbps
• 6 status LEDs
• 8 quasi-bidirectional lines brought out to IDC style expansion header
IrRx
:
• Sharp GP1UM28YK IR Receiver
IR Xmit
• 1/8” mini phono jack, 10 mA current drive
:
• two 8 pin serial EEPROM
• jumper selection simplifies ‘factory’ vs. ‘normal’ operation scenarios
JTAG
• JTAG connector for use with MDS NEXPERIA/TriMedia JTAG emulator or
other NEXPERIA/TriMedia compatible JTAG emulators
• 14 pin EJTAG pinout
• 10 pin mini-Din with stereo audio, SPDIF in, CVBS and S-video (kit
includes breakout cable)
• Four RCA jacks for component input (RGB, Sync)
• 8 pin mini-Din with stereo audio (channels 1 and 2), CVBS and S-video (kit
includes breakout cable)
• DVI-I (digital and analog) connector. Kit includes VGA adapter. Note that
only analog or digital mode can be used at a time.
• Three 1/8 stereo jacks for audio channels 2-8
• RCA jack (internal) for S/P DIF out
RS-232
• 10 pin IDC (kit includes IDC to 9 pin Dsub adapter)
• RJ-45 jack
• Full size PCI card
• Uses PCI +5V, +/- 12V
• On board supply for 3.3V and Vcore and V
DDR
generation