Motorola SURFBOARD SVG2500 User Manual
Page 127
10 SVG2500 VPN PAGES
112
Field
Description
Remote Endpoint Settings
Address group type
Set the remote VPN access group to one of the following group
types:
•
Single IP address — for one computer, enter the IP address
for the specific computer
•
IP address range — for a small range of computers, enter
the starting and ending IP addresses for the group of
consecutive IP address that will have access to the VPN
tunnel.
•
IP Subnet — for an entire subnet/network, enter the Subnet
and Mask
For IP address range and IP Subnet, enter the starting and ending
IP addresses for the group of consecutive IP address that will have
access to the VPN tunnel.
The remote VPN endpoint on the other side of the tunnel should
match the settings here for its local endpoint settings.
Identity
type
You can define the remote endpoint identity type to automatically
use the remote endpoint IP address, or as a user specified IP
address, fully qualified domain name (FQDN), or e-mail address.
This is the identity that the far endpoint will use for identification of
the VPN termination point and handshake.
The remote VPN endpoint on the other side of the tunnel should
match the settings here for its local endpoint settings.
Identity
Once the identity type is selected, enter the identity string here.
• For IP address, enter x.x.x.x.
• For FQDN, enter yourdomain.com
• For email address identity, enter [email protected]
The remote VPN endpoint on the other side of the tunnel should
match the settings here for its local endpoint settings.
Network
address
type
Select the remote endpoint's WAN address type: IP address or
Fully Qualified Domain Name (FQDN)
Remote
Address
Enter either the IP address of the remote endpoint or its FQDN.