Multitech MULTI MODEM II MT5600BA - Manual (Page 68)

6 Callback Security
62
MultiModemII User Guide
7. Press the Enter button again to go to the PASSWORD SETUP screen.
8. Press а, а to go to the ENTER PASSWORD #2? screen.
9. Repeat steps 3–7 to enter the next password.
10. Repeat as many times as necessary, up to memory location 30, until all pass-
words have been entered.
Warning: There is no way to review an entry to confirm that it has been entered cor-
rectly. If you attempt to look at a password entry by pressing the Enter button for an
ENTER PASSWORD #n?
screen, it is possible to accidentally erase the entry.
Assigning Callback Phone Numbers
At Command Method
1. Open a data communication program, such as HyperTerminal.
2. To store a callback phone number in the first memory location, type
AT#CBN01=xxxxxxxxxx , where xxxxxxxxxx is the dialing string, and press E
NTER
.
The dialing string can include the digits 0 through 9 and any of the following
characters: #, *, comma (,), semicolon (;), W, A, B, C, and D. Up to 30 characters
can be used. Example: AT#CBN01=9,16127853000. If a direct connection with
password protection, but without hangup and callback, is desired, the first char-
acter in the dialing string should be a hyphen (-).
3. To store a callback phone number in the second memory location, type
AT#CBN02=xxxxxxxxxx , where xxxxxxxxxx is the dialing string, and press E NTER .
Note that the memory location number in the command is incremented by one.
4. Repeat as many times as necessary, through memory location 30, until all dial-
ing strings have been entered.
Front Panel Method
1. Turn on the modem.
2. Starting at the STATUS screen, press the following buttons on the front panel:
в, в, а, в, в, а, в, в, а. The ENTER NUMBER #1? screen appears.
3. Press the Enter button on the front panel to select memory location 1. The
ENTER NUMBER screen appears.
4. Press the áß or â button several times to select the first character. If a direct
connection, without hangup and callback, is desired, the first character in the
dialing string should be a hyphen (-).
5. Press the à button to go to the next character in the dialing string.
Note: To backspace or to cancel an entry, press à several times.
6. The number can be up to 30 characters in length. Repeat steps 4 and 5 until the
number is entered, and then press the Enter button to store it. The NUMBER
STORED
screen should appear.