Moxa Technologies CP-132U - Manual (Page 12)

CP-132U Series User’s Manual 2-2
CP-132UL Series Block Diagram
CP-132UL Series boards’ hardware configuration for IRQ number and I/O address is
automatically assigned by the PCI BIOS. This means that the board MUST be plugged in
first before installing the driver software.
CP-132UL-I V2 (120 x 64.5 mm)
16 mm
[0.63 in]
4 WIRE RS422
MU860
120 mm [4.72 in]
121 mm
[4.7 6 in]
80.35 mm
[3.1 6 in]
64. 4 mm
[2.5 3 in]
CP-132UL-
V2I
41.7 mm
[1.64 in]
2 WIRE RS485
S1 S2
TX1 TX2
RX1 RX2
ON ON
Port1
Port2
JP2
JP1
NOTE: Use JP1/2 to activate the Termination Resistors for ports 1/2.
Open Termination Resistor is NOT active
Short Termination Resistor is ACTIVE