Motorola POWERBROADBAND T2-2500 User Manual
Page 51
Appendix C
Motorola, Inc.
549453-001-00-a
Page 51 of 51
A
A
p
p
p
p
e
e
n
n
d
d
i
i
x
x
C
C
:
:
C
C
o
o
m
m
p
p
l
l
i
i
a
a
n
n
c
c
e
e
FCC Part 15A
This device complies with part 15 of the FCC Rules. Operation is subject to two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT SAFETY INSTRUCTIONS
mT2a Switch
CAUTION:
For installation only in a Restricted Access Location by trained service personnel.
CAUTION:
Equipment must be connected to an earthed mains socket-outlet.
CAUTION –
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
CAUTION:
The power supply cord plug serves as the main disconnect for the product. The socket-outlet shall be
installed near the product and be readily accessible.
CAUTION:
Voltages present which are above TNV-3 (POTS) limits. A cover must be installed over the punch down
blocks with a HV (High Voltage) warning label (supplied).
The maximum operating ambient temperature is 50 degrees Celsius.
When installing the mT2a Switch in an equipment rack, consider the following potential hazards:
Elevated Operating Ambient Temperature – If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than the room ambient. Therefore, consideration should be given
to installing the equipment in an environment compatible with the manufacturer’s maximum rated ambient
temperature (Tmra).
Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and the
effect that overloading of circuits might have on overcurrent protection and supply wiring. Appropriate consideration of
equipment nameplate ratings should be used when addressing this concern.
Reliable Earthing – Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to the branch circuit (e.g., use
of power strips).
m2a WallPlate
CAUTION:
Use only power supplies listed in the user manual
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire,
electric shock and injury to persons, including the following:
1. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool.
2. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electric shock from lightning.
3. Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS