Meco Bonza Deluxe Series - Manual (Page 25)

· Wash the porcelain coated Cooking Grids (37) with
a mixture of hot water and baking soda.
· Empty the foil pan and grease tray after each
cooking session so excessive grease does not
accumulate. Failure to remove grease may result in
grease
dripping onto the cart and/or a grease fire in
· Open Hood before lighting the grill to prevent an
explosion from gas build-up.
· Always inspect the gas hose and regulator assembly
before each use. If the hose is cut, damaged,
or shows signs of excessive abrasion or wear, do not
use the LP gas grill. Contact the manufacturer, as
the hose and regulator assembly must be replaced
with an assembly specified by the manufacturer prior
to further use of the LP gas grill.
· Never use lighter fluids with your grill.
3) From the “Off” position, push control knob in on the left
burner and turn counter-clockwise until you feel
resistance. Pause 4 seconds, then continue turning the con-
trol knob until a click is heard and the burner is lit.
4) Light the remaining burners by turning the control knob
counter-clockwise. Your grill has a crossover ignition system
that allows the burners to light successively off one another.
Confirm each burner is lit before lighting another burner.
5) If any of the burners do not light, repeat Step 3. The burner
should light within three or four attempts. If burner still does
not light, try the next burners from left to right.
WARNING: If any or all burners fail to light after
following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above lighting
procedures.
Note:If the burners still fail to light, refer to the
Troubleshooting page. The burner can be lit manually, see
Manual Lighting of the Grill.
6) After ignition, preheat the grill by turning the control to
“High” position for 3-5 minutes. The grill should be
pre-heated before every cooking session. The hood
should be closed during preheating.
WARNING: If a burner goes out during the cooking cy-
cle, turn all knobs to the off position and close the valve
on the LP cylinder. Open hood and wait five minutes
before attempting to relight the grill.
Preparation Before Cooking
Lighting the Grill Using the Integra-
Spark Ignition System
25
2. Turn LP cylinder handle
counter-clockwise - “ON”
1. Open hood
3. Push in and turn control knob
counter-clockwise until you feel
resistance, wait 4 seconds then
continue until a click is heard
and the burner is lit.
How to light your LP gas grill when planning to
cook using only LP gas (See diagram
below
for illustrations).
1) Open Hood.
2) Important: Make sure control knobs are
turned “off” first. Make sure the louver adjusting
knob is pulled out for gas mode. Make sure
cooking grids are installed. Open the LP gas cylinder
Your Grill can be used in one of three different
cooking modes:
1. LP Gas only.
2. LP Gas with charcoal or wood chunks for
flavor. 3. Charcoal Only.
COOKING MODE: LP GAS ONLY Flavor Activator adjusting
knob located behind this
leg. Pull adjusting
knob until it stops for gas
mode. Flavor Activators will
form a tent shape.
Push adjusting
knob in until it stops for
charcoal mode. The Flavor
Activators will form a more