MITSUBISHI ELECTRIC WS-65819 - Manual (Page 13)

13 13
1 2
3
4 5
6
7
Y
G
Pb
B
Pr
R
V
H
HIGH RESOLUTION INPUT
INPUT
3 PIP
S-VIDEO
COMPONENT 480i /480p
1 (YPrPb) 2 (YPrPb)
DTV (YPrPb/GRBHV)
480i /480p /1080i
VIDEO
MONITOR
ACTIVE A/V
NETWORK
IR - HOME
THEATER
2 1
OUTPUT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
ANT-B LOOP OUT ANT-A
Part II: Installation
B
ac
k P
an
el F
un
cti
on
s
Back Panel
1 Inputs 1-3
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, laser disc
player, or other A/V device to the TV. Please note that with each input, you may connect to
the S-VIDEO or VIDEO terminal, but not both.
2 Output (Monitor and PIP)
The Monitor Output sends the TV audio and video signals, excluding component video or
DTV video, to an A/V receiver or other equipment. The PIP output sends the PIP’s or
POP’s audio signal to an amplifier or wireless headphones. If no PIP or POP is displayed,
the PIP output will send the main picture audio signal.
3
Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive signals from VHF/UHF antennas or a cable system. LOOP OUT
sends the ANT-A signal out to another component, such as a cable box or VCR.
4
Active AV Network™
This interface connects Mitsubishi products that have an AV Network terminal.
5
IR Home Theater
Connecting an IR emitter here allows the TV to automatically change a Mitsubishi digital
A/V receiver’s input in a home theater setup.
6
Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video
outputs, such as a DVD player. Please see Appendix B, page 65, for signal compatibility.
7 DTV Input
This input is used to connect a DTV receiver, and can be configured for HDTV component,
RGB sync on green, and RGB plus H&V. Please see Appendix B, page 65, for signal
compatibility.