Meco 8452-5-SS1 - Manual (Page 7)

7
STEP 4) CASTER ASSEMBLY:
Lay cart on the floor with Back Panel side down. Assemble Fixed Casters (23) to the LEFT Side of
Bottom Panel and Swivel Lock Casters (24) to the RIGHT Side of Bottom Panel. Insert eight M6x15
Bolts (7) through the caster bracket holes into the threaded holes in the Bottom Panel. (FIG. 4A &
4B) Tighten the screws. Push the lever on the Swivel Lock Caster to lock so the caster wheel does
not roll. (FIG. 4C) Set cart assembly up on the the floor.
(24) LOCKING CASTER
(23) FIXED CASTER
FIG. 4A FIG. 4B
STEP 5) DOOR ASSEMBLY:
Install LEFT Door (26/27) and RIGHT Door (28/29). (FIG. 5A) Note: Hinge Pins are spring-loaded.
Drop bottom door pin into Bottom Panel hole. (FIG. 5B) Swing top of door toward hole in top
Panel. Depress spring pin with thumb while sliding pin into Top Panel hole until it snaps into
place. (FIG. 5C)
(26/27) LEFT DOOR SHOWN,
RIGHT DOOR SAME.
FIG. 5A
FIG. 5C
FIG. 5B
FIG. 4C
(7) M6 x 15 BOLT
PUSH LEVER
DOWN THIS
SIDE TO LOCK
PUSH LEVER
DOWN THIS
SIDE TO
UNLOCK