IBM THINKCENTRE 8086 User Manual
Page 32
2.
Pivot
the
drive
bay
assembly
upward
to
gain
access
to
the
hard
disk
drive.
3.
Disconnect
the
signal
and
power
cables
from
the
rear
of
the
hard
disk
drive.
4.
Lift
the
hard
disk
drive
and
bracket
up
to
remove
it
from
the
drive
bay.
5.
Note
the
orientation
of
the
hard
disk
drive
in
the
plastic
bracket.
6.
Remove
the
drive
by
flexing
the
plastic
enough
to
slide
the
drive
out.
7.
Install
the
hard
disk
drive
into
the
plastic
bracket
by
flexing
the
plastic
enough
to
slide
the
drive
in.
8.
Install
the
hard
disk
drive
and
bracket
into
the
bay
until
it
snaps
into
position.
9.
If
you
are
replacing
a
parallel
ATA
hard
disk
drive,
place
the
master/slave
jumper
on
the
drive
in
the
same
position
as
on
the
drive
being
replaced.
Also
refer
to
any
instructions
that
come
with
the
drive.
18
User
Guide