Charging the battery, Ƽ warning – Invacare 1900 User Manual
Page 14
SECTION 2—OPERATING THE BATH LIFT
14
FIGURE 2.8 Mounting the Battery Charger
Charging the Battery
NOTE: For this procedure, refer to FIGURE 2.9.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1. Lift up on the handle on the back of the battery (Detail “A”).
2. Lift the battery up and out from the control box.
ƽ WARNING
Make sure there is an audible click when
mounting battery either on the battery
charger or the control box to confirm
proper mounting. Otherwise, injury or
damage may occur.
3. Place the battery on the battery charger
(Detail “B”).
NOTE: There will be an audible click.
NOTE: The charge LED will illuminate. When
charging is complete, the charge LED will stop
illuminating.
NOTE: A battery needing to be fully recharged
will take approximately four hours.
4. Lift up on the handle on the back of the
battery (Detail “A”).
5. Lift the battery up and out away from
the battery charger.
6. Reinstall the battery onto the control
box of the lift (Detail “B”).
7. Push the battery into the lift housing and
rock slightly until it locks into place
(Detail “C”).
NOTE: There will be an audible click when the
battery locks into place (Detail “D”).
FIGURE 2.9 Charging the Battery
Mounting Bracket
(STEP 6)
Mounting Screws
(STEP 7)
Battery Charger with
Mounting Bracket
(STEP 5)
BOTTOM
Mounting Screw
(STEP 4)
Handle
Audible
Click
Control Box
Battery
DETAIL “A”
DETAIL “B”
Battery
Control Box
Battery
Control
Box
Battery
DETAIL “C”
DETAIL “D”
NOTE: The battery is
shown being removed
from and installed into a
control box. Removing
and installing a battery
into a battery charger is
done the same way.
Emergency Pull Pin