Programming the media gateway (pxamg) – iSimple ISFD11 User Manual

Page 5

Advertising
background image

3

4. Programming the Media Gateway

(PXAMG)

The Media Gateway may need to be programmed before installation. To program
the interface you will need to set the dip switches located on the side of the interface

to the proper configuration listed below. Prior to installation the switches are in their
default setting of “off” in the up position and are turned “on” when switched down.
Refer to the chart below.

Radio Requirements

All 2005-2008, select 2009-2010 Non-Navigation Center Stack** - All 2005-2008

radios, navigation or non-navigation, that feature an “AUX” or “SIRIUS” button are
compatible.* Select 2009-2010 non-navigation center stack radios that feature a
“Sirius” button are compatible. In these vehicles the Media Gateway emulates a
satellite tuner, therefore it is required that the vehicle be either equipped with an
external satellite tuner or be Satellite Radio ready.

*Refer to www.isimplesolutions.com for the most updated compatibility information.

**Current vehicles equipped with center stack radio:
• 2009-2010 Ford F-150

• 2009 Ford Flex

• 2009 Lincoln MKS

• 2010 Ford Fusion

• 2010 Ford Mustang

• 2010 Lincoln MKZ

• 2010 Mercury Milan

*In the event that Satellite Radio text appears on the radio
and audio is playing but control of the Sirius tuner from the
radio buttons is lost,
1. Disconnect the Media Gateway from the vehicle harness
2. Switch dip-switch #1 to the ON position

3. Wait five minutes
4. Reconnect the Media Gateway interface to the vehicle
Control of the iPod from the radio controls will now be
possible.

4A. When installing the Media Gateway for
use with the SCC1 Sirius Satellite Radio
tuner, dipswitch 2 needs to be ON (down)
prior to installation.

Advertising