Iluv i1166 - Manual (Page 13)

iLuv | 24 i1166 | V10M10_IM_EN_091509 23 | iLuv
Video Setup
CARE AND MAINTENANCE GUIDE
1. Press SETUP in the Stop mode.
2. Press to select VIDEO SETUP. Press or to select the option (BRIGHTNESS, CONTRAST, HUE,
SATURATION, SHARPNESS) and press SELECT.
3. Press
or to adjust and press SELECT. The screen will change to your selected setting.
4. Repeat steps 2 and 3 above to choose another option.
5. To exit the SETUP MENU and return to a normal screen, press SETUP again.
· Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with
the shiny, unprinted side of the disc.
· Do not attach adhesive tape, stickers etc., to the disc label.
· Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive
cleaners to clean the disc. If necessary, use a CD cleaning kit.
· If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
· When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc.
Never wipe in circular motions.
· To remove a disc from its storage case, press down on the centre of the case and lift the disc outs,
holding it carefully by the edges.
· Fingerprints and dust should be carefully wiped off the disc’s recorded surface with a soft cloth.
Unlike conventional records. compact disc have no groove to collect dust and microscopic debris,
so gently wiping with a soft cloth should remove most particles.
CLEANING THE UNIT
· To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
· The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use caution
when cleaning and wiping the plastic parts.
· If the cabinets become dusty wipe them with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinets.
· If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth
slightly dampened with a mild soap and water solution. Never use abrasive cloths or polishes as these
will damage the finish of your unit.
Caution: Never allow any water or other liquids to get inside the unit while cleaning.
OPERATIONAL INSTRUCTIONS
Speaker Setup
1. Press SETUP in the stop mode.
2. Press to select SPEAKER SETUP. Press or to select DOWNMIX.
3. Press
or to selected either MONO (LT/RT) or STEREO.
4. To exit the SETUP MENU and return to a normal screen, press SETUP again.
LCD Setting
1. Press LCD SET of remote control to select Brightness, Contrast, Saturation and Aspect (16:9 or 4:3).
2. Press VOLUME +/- on remote control to change the settings of brightness, color, contrast and
screen aspect.