IBM MX5 - Manual (Page 17)

Pocket PC 2002 The volume is adjusted using Windows icon | Settings |
Personal tab | Sounds & Notifications icon then select the Notifications tab.
Using the Keypad
Note: “Enable sounds for” must be enabled before the following key sequences
will adjust the volume.
To adjust speaker volume, locate the <V> key and the Blue key.
Adjust the speaker volume by pressing the:
• Blue key, then the <V> key to enter Volume change mode.
• Use the Up Arrow and Down Arrow keys to adjust volume until the speaker
volume is satisfactory.
• Press the Enter key to exit this mode.
Using the Touch Screen
Pocket PC 200 0 Tap the Windows icon | Settings | Personal tab | Sounds &
Reminders icon. Then select the Volume tab.
Pocket PC 2002 Tap the Windows icon | Settings | Personal tab | Sounds &
Notifications icon. Then select the Notifications tab.
Change the setting and tap OK to save the change. You can also select / deselect
sounds for key clicks and screen taps and whether each is loud or soft.
Sounds specific to primary events are selected using the options on the Sounds
tab.
Reminder/Notifications tones are selected using the options on the
Reminders/Notifications tab.
As the volume scrollbar is moved between Loud and Silent, the computer beeps
each time the volume increases or decreases in decibel range.
Troubleshooting
Blue+V puts the MX5 in ‘Volume Adjust’ mode.
Shift+Blue+Shift puts the unit in ‘Blue’ Mode which, when followed by ‘V’, puts
the unit in ‘Volume Adjust’ mode as well.
If the MX5 is responding to touch input, but does not respond to keypad (hard or
soft) input, the MX5 may still be in Volume Adjust mode.
Press Enter to cancel (exit) Volume Adjust mode. After pressing enter, the MX5
should start responding to key input.