IBM MX5 - Manual (Page 14)

6. After securing the bottom of the strap to the MX5, loosen the closed loop
fastener strap and then secure the upper bracket to the unit with a
screw.
Removal
1. Separate the closed loop fastener tabs and loosen the strap through the
upper bracket.
2. Using a Phillips screwdriver, remove the upper bracket screw.
3. Pull the bottom assembly from the slots in the bottom back of the MX5..
Slide the bottom bracket out and away from the MX5 when replacing the Main
Battery Pack.
Periodically check the handstrap for wear and the connection for tightness. If the
handstrap gets worn or damaged, it must be replaced. If the handstrap
connection loosens, it must be tightened before the MX5 is placed in service.
Tap the Touchscreen with a Stylus
Note: Always use the point of the stylus for tapping or making strokes on the
display. Never use an actual pen, pencil or sharp object to write on the
touch screen.
Hold the stylus as if it were a pen or pencil. Touch an element on the screen with
the tip of the stylus then remove the stylus from the screen. Firmly press the
stylus into the stylus holder on the MX5 when the stylus is not in use.
Like using a mouse to left-click icons on a computer screen, using the stylus to
tap icons on the MX5 display is the basic action that can:
• Open applications
• Choose menu commands
• Select options in dialog boxes or drop-down boxes
• Drag the slider in a scroll bar
• Select text by dragging the stylus across the text
• Place the cursor in a text box prior to typing in data or retrieving data using
the integrated barcode scanner or an input/output device connected to the
serial port.
An extra or replacement stylus can be ordered from LXE. See the section titled
"Accessories" for the stylus part number.
Keypad Shortcuts
Use keyboard shortcuts instead of the stylus when the MX5 is running Pocket PC.
• Press Tab and a Left or Right Arrow key to select a file.
• Press Shift and an Up or Down Arrow key to select several files. Press
Shift+Arrow, then Shift+Arrow again for each additional file selected.
• Once you've selected a file, press Alt then press Enter to open its Properties