Battery hot-swapping, Checking battery status, Battery chargers – IBM MX5 User Manual

Page 26: Cradles

Advertising
background image

removed or has failed. The backup battery requires no user intervention.

Replacement is performed by LXE. LXE recommends an MX5 in storage have a

charged main battery pack installed.

Note: This mobile device's backup battery maintains it’s charge by drawing

power from the main battery pack. Always store unused devices with a

fully charged main battery pack installed. LXE recommends an in-use

mobile device be frequently connected to an external power source to

retain optimum power levels in the main battery pack and the backup

battery. When the backup battery and main battery pack are dead, the

mobile device reverts to setup defaults when a fully charged main

battery pack is installed and the device is powered On again.

Battery Hot-Swapping

Replace the main battery pack after first pressing the power key and placing the

MX5 in Suspend Mode. LXE recommends any work in progress be saved prior to

replacing the main battery pack.
Simply replace the discharged main battery with a fully-charged main battery.
The backup battery will retain data during a main battery hot-swap.
Place the battery in the battery well, making sure the tabs on the bottom of the

battery pack fit into the slots at the bottom end of the battery well. Push the

battery down into the battery well while fastening the screws. Fasten the screws

tight enough to allow the rubber gasket to create a watertight seal. If the screws
do not easily twist into the threaded opening, remove the battery and repeat the

process.

Checking Battery Status

Tap the Windows icon | Settings | System | Handheld | Power tab. Battery

level, status and charge remaining is displayed.
Tap the Windows icon | Settings | System | Handheld | Battery Info tab

to view technical information and number of charge cycles for the Main Battery.
Main Battery ChargingLeft GREEN LED slow flashing.
Main Battery Low

Low Battery Icon appears on the

“Today” page.

Main Battery Fully

Charged

Left GREEN LED stops flashing; is

solid ON.

Charge / battery fault Left GREEN LED has quick double

flashes.

Backup Battery

Dialog appears on the screen to alert

Advertising
This manual is related to the following products: