Insignia NS-C3111 - Manual (Page 12)

11
NS-C3111 Car Stereo CD/MP3 Player
www.insignia-products.com
Viewing and setting the time
You can view the time by pressing the DISP button.
To set the time:
1 Press the PWR button to turn on your radio.
2 Press and hold the DISP button until the display flashes.
3 Set the hours by turning the SEL knob to the right (clockwise).
4 Set the minutes by turning the SEL knob to the left
(counterclockwise).
Programming and using radio station presets
You can program as many as 6 radio station presets for each
available band (FM1, FM2, FM3, AM1, and AM2). After you program
a station, you can tune to the station by pressing one of the numbered
preset buttons on the front of your car stereo.
To program a radio station:
1 Press the PWR button to turn on your radio.
2 Select the band you want by pressing the BD/SUB
(band/subwoofer) button to select FM1, FM2, FM3, AM1, or AM2.
The current band appears on the display.
3 Tune the radio to the station of your choice by pressing the or
button.
4 Press and hold the preset number button to which you want to
assign the station until the radio beeps once (hold the button for
about two seconds).
5 Repeat Steps 2 through 4 to program additional presets.
BEEP mode (to
beep when
buttons are
pressed) ON
OFF (default) 1 × (for more than
two seconds), then
2 ×.
SEEK mode Seek 1 (default)–Stops at every station
detected. Press the
or button
again to continue.
Seek 2–Does not stop at any station
until you release the
or button.
1 × (for more than
two seconds), then
3 ×.
VOL LAST/VOL
ADJ VOL LAST (default)–Sets the volume
level to the last setting used.
VOL ADJ–A low initial volume is set and
you can adjust the volume. 1 × (for more than
two seconds), then
4 ×.
Adjustment or
mode setting
Options
Press the SEL
knob