Installing crutch and cane carrier, Note: for this procedure, refer to figure 1, Position the base parallel to the step tube – Invacare 1305L User Manual
Page 2: Caution, Remove the upper back upholstery screw and washer, Step tube, Figure 1 installing crutch and cane carrier
Installing Crutch and Cane Carrier
2
Installing Crutch and Cane Carrier
NOTE: For this procedure, refer to FIGURE 1.
1. Slide the clamp with the base attached over the end of the step tube of the wheelchair.
Ensure the base is towards the inside of the wheelchair.
2. Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to avoid bending spokes when folding the
wheelchair.
3. Securely tighten the locknut that secures the base to the step tube of the wheelchair.
4. Remove the upper back upholstery screw and washer.
5. Align the strap with the back upholstery screw mounting hole.
6. Reinstall the back upholstery screw and washer and secure the strap to the wheelchair.
7. The base cleans easily with any chrome or glass cleaner. The strap can be cleaned with
mild soap and water.
FIGURE 1 Installing Crutch and Cane Carrier
Step
Tube
Locknut
Clamp
Base
Strap