Insignia Kix NS-1A10F - Manual (Page 6)

6
Insignia NS-1A10f/NS-1A10s Digital Music Player
www.insignia-products.com
To charge the battery:
1 Turn on your computer.
2 Connect the supplied mini USB 2.0 cable to
the mini USB jack on the player and a
standard USB jack on your computer. When
the cable is connected correctly, the player
begins recharging its battery using the USB
connection, and the message USB
Connected appears on the player.
As the battery charges, the LED backlights
behind the buttons blink every five seconds.
Once the battery is fully charged, the LED
stops blinking.
Connecting headphones
You can use any headphones with a standard
3.5 mm stereo audio plug.
To connect headphones:
•
Plug headphones or the provided earphones
into the earphone/ headphone jack on the
music player.
Installing the Best Buy Digital Music Store
software
To install the software:
1 Insert the Insignia software CD into your
computer's CD or DVD drive. The software
installation program starts.
-OR-
If the installation program doesn't start
automatically, double-click My Computer on
your desktop, double-click the CD drive that
contains the Insignia CD, then double-click
the file setup.exe. The software installation
program starts.
2 Follow the on-screen instructions to finish the
installation.
Using your digital music
player
Turning your player on and off
To turn your player on or off:
• Press and hold (Power/ Menu) for two
seconds.
Resetting the player
If the player stops responding to button presses,
you should reset the player.
To reset your player:
• Press and hold (Power/ Menu) for seven
seconds to force a reset. This will fully reset
the player.
Changing the volume
To change the volume:
• Press (Volume Up) or (Volume
Down).
Locking the buttons
You can prevent accidental button operation by
locking the buttons.
To lock the buttons:
•
Slide the HOLD switch in the direction of the
arrow. An image of the hold button in the
HOLD position appears on the screen.
Note
If the following icon appears on the display, you
must charge your player.
Note
You can also use a USB charger to charge your
player. The charger must supply 0.5 Amps at
5 Volts to charge the player.
Note
To use the FM radio, you must connect the
provided earphones because they act as the FM
antenna. To substitute for the earphones, you can
use any headphones with unshielded wires.
Tip
For iTunes Drag and Drop support, use File &
Folder (MSC) USB mode. Your Insignia MP3
player will only play iTunes MP3 files that you drag
and drop from iTunes. For information on changing
USB modes, see “Select the USB mode” on page
27.