Ingersoll-Rand SMB030 - Manual (Page 4)

Series
Hoist
Capacity
Lift
(Hoist load chain/
hook travel)
Hand Chain
(Hand chain is 2 ft
less than lift)
Slip
Clutch
SMB= Silver Series
Manual
Chain Hoist
005 = 1/2 metric ton / 500 kg
010 = 1 metric ton / 1,000 kg
015 = 1-1/2 metric ton /
1,500 kg
020 = 2 metric ton / 2,000 kg
030 = 3 metric ton / 3,000 kg
050 = 5 metric ton / 5,000 kg
10 = 10 ft (3 m)
(standard)
15 = 15 ft (5 m)
20 = 20 ft (6 m)
XX = Specify length
F
= Hoist without
load chain
8 = 8 feet (standard)
(10 foot lift minus 2 ft)
13 = 13 feet
(15 foot lift minus 2 ft)
18 = 18 feet
(20 foot lift minus 2 ft)
XX = Specify length
V = Slip Clutch
(standard)
General Specifications
Model No.
Rated
Capacity
(metric
tons)*
Pull to Lift Rated Load Load
Chain Size
(mm)
Hand Chain
Overhauled to Lift
Load 1 ft (0.3 m)
No. of
Chain
Falls
Hoist Net Weight with
Standard 10 ft (3 m)
Lift
lb kg ft m lb kg
SMB005 1/2 55.5 25 5 x 15 31.5 9.6
1
23.5 10.7
SMB010 1 64 29 6 x 18 53.1 16 26.8 12.2
SMB015 1-1/2 69 31 7 x 21 71.6 22 38.5 17.5
SMB020 2 77 35 8 x 24 84.6 26
1
42.4 19.3
SMB030 3 100 45 10 x 30 99.4 30 70.4 32
SMB050 5 83.5 38 9 x 27 213.2 65 2 90.2 41
* One metric ton = 2,200 lbs.
4 MHD56391 - Edition 2
INSTALLATION
Prior to installing the hoist, carefully inspect it for possible
shipping damage.
Hoists are supplied fully lubricated from the factory. Lubrication
of the load chain is recommended before initial hoist operation.
(Dwg. MHP0832)
WARNING
• A falling load can cause injury or death. Before installing,
read “SAFETY INFORMATION”.
CAUTION
• Owners and users are advised to examine specific, local or
other regulations, including American Society of Mechanical
Engineers and/or OSHA Regulations which may apply to a
particular type of use of this product, before installing or
putting hoist to use.
Hoists are designed to provide a 4:1 safety factor. The supporting
structures and load-attaching devices used in conjunction with this
hoist must provide adequate support to handle all hoist operations,
plus the weight of the hoist and attached equipment. If in doubt,
consult a registered structural engineer.
The SMB manual chain hoist must be used in a vertical position to
provide a straight line pull from top hook to bottom hook. The
hoist must be positioned so that it does not contact the support
members when in use. When operating in limited areas suitable
lifting attachments or slings must be used to prevent the hoist body
and hand chain from being obstructed.