Running a wash cycle – Indesit SIXL 125 S User Manual

Page 6

Advertising
background image

6

GB

Running a wash cycle

Note:

Once the appliance has been installed, and

before you use it for the first time, run a wash cycle

with detergent and no laundry, using the

programme.
1. SWITCH ON THE MACHINE by pressing the ON/

OFF button. The icons for the START

PROGRAMME buttons begin to flash and the

WASHING TIME INDICATOR lights light up in a

fixed manner, to indicate that the washing machine

is ready to receive instructions.

2. LOAD THE LAUNDRY. Open the door using the

handle. Load the laundry, making sure you do not

exceed the maximum load value indicated in the

table of programmes on the following page.

3. MEASURE OUT THE DETERGENT AND

ADDITIVES.

Pour the detergents into the drawer located inside

the porthole door, taking care not to exceed the

maximum levels indicated on the surface of the

drawer and by the floating indicators. For further

details, please refer to the chapter entitled

“Description of the machine”.

4. CLOSE THE DOOR.

5. START THE

WASHING

PROGRAMME by

pressing the

corresponding START

PROGRAMME

BUTTON. The icon

corresponding to the

selected programme

illuminates in a fixed

manner, and all the wash time indicator lights

switch off. The DOOR LOCKED indicator light

illuminates in a fixed manner, to signal the

activation of the door safety device.
For a description of the wash programmes

available, please refer to the chapter entitled

“Wash programmes”.
 The procedure used to start the DELICATES

programme is different; for further details please

refer to the chapter entitled “Wash programmes”.

During the programme

the WASH TIME

INDICATOR lights

illuminate in sequence,

indicating how much of

the programme has

already been

completed.

As soon as the

programme has been

selected, all the

indicator lights switch off.

During the wash cycle

they switch on one by

one, in sequence, in a

clockwise direction. The

diagram at the side

refers to a situation in

which approximately

50% of the cycle has

been completed.

At the end of the cycle

all the indicator lights are

switched on and flashing.

6. The WASH PROGRAMME can be SUSPENDED by

pressing the illuminated start programme button

which begins to flash. After approximately two

minutes the DOOR LOCKED indicator light will

switch off to indicate that the door may be

opened. To restart the wash programme, close the

door again and press the corresponding start button

once more.

However, if there is water in the tub exceeding the

safety level, it will not be possible to open the door.

The machine should be switched off by pressing for
approximately 2 seconds the ON/OFF button

and holding it for approximately two seconds, then

waiting for the water to be drained automatically.

7. AT THE END OF THE PROGRAMME

At the end of the wash programme, the icon

corresponding to the selected programme remains

lit in a fixed manner, while all the washing time

indicator lights begin to flash.

To start a new wash cycle the machine must be

switched off and switched back on again, by
pressing the ON/OFF button TWO TIMES.

Advertising
This manual is related to the following products: