Invacare 1141448 - Manual (Page 7)

Part No 1141448 7 InTouch™ Stabilite/Stabilite OM Cushion
Modification for approximately 1-inch of obliquity
NOTE: This modification can be done on either side of the cushion.
1. Determine which side of the cushion needs to be lowered.
2. Remove the cushion from inner and outer covers. Refer to Removing/Installing the Cushion Covers
on page 4.
3. On the side of the cushion that needs to be lowered, remove the obliquity insert by pulling on the
tab.
4. Align the chamfered edges on the obliquity inserts as shown in DETAIL “B” of FIGURE 5.
5. Put the obliquity insert removed in step 3 onto the obliquity insert that is in place on the cushion as
shown in DETAIL “B” of FIGURE 5.
6. Apply pressure along the hook and loop strip. Pull on the tab to make sure that the obliquity inserts
are securely in place before installing the covers.
7. Install the cushion into inner and outer covers. Refer to Removing/Installing the Cushion Covers on
page 4.
FIGURE 5 Modifying the Cushion to Accommodate Obliquity
DETAIL “A” - MODIFICATION FOR APPROXIMATELY
½-INCH OF OBLIQUITY
Obliquity Inserts
Tab
Tab
Top of cushion
Bottom of cushion
Bottom of cushion
Top of
cushion
DETAIL “B” - MODIFICATION FOR APPROXIMATELY
1-INCH OF OBLIQUITY
Bottom of cushion
Top of cushion
Remove one obliquity insert for ½-inch modification
Align the
chamfered edges of
the obliquity inserts
Put the obliquity insert removed in STEP 3 onto the obliquity
insert in place on the cushion for 1-inch modification
NOTE: This modification can be done on either side
of the cushion. NOTE: This modification can be done on either side
of the cushion.
Hook and loop strip
Tab
Hook and loop strip
Tab