Integra DTR-5.3 - Manual (Page 34)

34
Turning on the power from the remote controller
Before you can use the remote controller, you must perform step 1
above and place the DTR-6.3/5.3 in the standby state.
1. Press the RCVR Mode button.
The RCVR Mode button lights green.
2. Press the ON button to turn on the
DTR-6.3/5.3 (take it out of the
standby state).
To return the DTR-6.3/5.3 to the standby
state, press the Standby button.
Memory preservation
The DTR-6.3/5.3 does not require memory preservation batteries.
A built-in memory backup system preserves the contents of
memory (e.g., speaker settings and surround settings) during
power failures and even when the unit is unplugged. The unit
must be plugged in order to change the back-up system.
The length of time that the memory will be preserved will vary
depending on the ambient climate. On the average, memory
contents are protected over a period of a few weeks after the last
time the unit has been unplugged. This period may be shorter
when the unit is exposed to a highly humid climate.
On
RCVR
Mode
Standby Standby/On Standby indicator
To wall outlet
• Before you plug in the DTR-6.3/5.3, confirm that all connections
have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
Turning on the power
1. Plug the power cord into an AC wall outlet.
The Standby indicator will light up.
2. Press the Standby/On button to turn on the DTR-6.3/
5.3.
The display will light up and the Standby indicator will turn off.
If you press the Standby/On button again, the receiver returns to
standby state.
Connecting the power
Turn off
Diagram for DTR-6.3