Invacare 1335 - Manual (Page 2)

3. Determine an acceptable mounting location for the non-folding device.
NOTE: The location depends on the wheelchair model. The non-folding device can be mounted to
7/8-inch (using plastic insert guide) or 1-inch diameter tubing. For any wheelchair model, it can
be installed on to at least one of the following locations:
A. Rear upright tubes (Detail “A”)
B. Rear step tubes (Detail “A”)
C. Upper frame tubing (Detail “B”)
NOTE: When mounting on the upper frame tubing under the seat, the non-folding device MUST
be mounted just in front of the rear seat guides.
4. Unfold the wheelchair. Refer to owner’s manual supplied with the wheelchair.
5. Position one clamp of the non-folding device in the pre-determined position from STEP
3 as shown in FIGURE 1. If you are mounting this device on 7/8-inch tube, put the plastic
insert guides around the 7/8-inch tube under the clamps.
6. Squeeze the two halves of the clamp together.
7. Insert the hex head bolt through the clamp.
8. Install the locknut onto the hex head bolt.
9. Extend the non-folding device to position the remaining clamp on the opposite side of
the wheelchair in the position determined in STEP 3.
10. Repeat STEPS 5-7 to secure the remaining clamp.
NOTE: Ensure clamps at both ends sit flush on the wheelchair frame and DO NOT interfere with
wheelchair function.
11. Securely tighten the locknuts on the hex head bolts in the clamps at both ends of the
non-folding device.
12. Securely tighten the locknut on the lug bolt in the adjustment clamp.
FIGURE 1 Installing the Non-Folding Device
Locknuts Rear Upright
Tube
Clamp
Adjustment
Clamp
Hex Head Bolt
Rear Step
Tube
DETAIL “A” DETAIL “B”
Adjustment
Clamp
Rear Seat
Guides
Hex
Head Bolt
Locknuts
Upper Frame
Tubing
Clamp
Lug
Bolt
Invacare Corporation www.invacare.com
USA
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Canada
570 Matheson Blvd E Unit 8
Mississauga Ontario
L4Z 4G4 Canada
800-668-5324
Invacare, Yes, you can. and The Medallion
Design are registered trademarks of
Invacare Corporation.
©2006 Invacare Corporation
Part No. 00083x072
Rev F - 05/3/06