Iqua BHS - 601 - Manual (Page 7)

Low Battery
When the headset is on and the battery becomes low, the LED will blink red color and the
headset will "beep" 3 times every 20 seconds. At that time, please recharge the battery as
described in the above step as "Charging Your Headset".
Turn on the Headset
Constantly press
Button for 5 seconds until you hear 2 short beeps. The LED will blink blue
color for 3 times.
Turn off the Headset
Constantly press
Button for 2 seconds until you hear 2 short beeps. The LED will blink red
color for 3 times.
Pairing Your Headset
This headset must use a Bluetooth enabled mobile phone. Configuration set up as below
for the first time use.
– Keep headset and phone around 1 meter.
– Assure headset is turned off.
– Constantly press
Button until LED blinks red and blue in turn.
– Initiate Bluetooth function of phone & search for Bluetooth devices.
– Phone will start searching for Bluetooth devices. If it's successful, phone screen will show the
name of obtained device - "BHS-601". Press "Yes" to pair this headset to the phone.
– Input ID code of headset - "0000". Press "Yes" to complete pairing. Meanwhile, this headset
is under Standby -mode - BLUE LED blinks 5 times.
– Back to main menu of phone. Headset is under Standby -mode and ready for Bluetooth
communication. Please locate this headset within 10 meters (max.) to phone.
Notice: If pairing process cannot complete within 2 minutes, LED will stop blinking red and
blue in turn. Please follow up above steps to repairing again.