InFocus DP9200 User Manual

InFocus Projectors

Advertising
background image

Copyright © 1997-2004 InFocus Corporation.

All Rights Reserved.

ASK Proxima DP9200 Projectors
Frequently Asked Questions

How do I set up the DP9200/9210 remote mouse?

The DP9200 can emulate a mouse when connected to a computer using one of the remote mouse cables (serial, PS/2 or Mac

ADB) provided with the projector. In most cases, the DP will automatically detect and configure the remote when the

computer boots. There are a few cases where the DP will not be detected as a mouse.


Before you begin, ensure that if using:

Windows 95: In Control Panel, if using the serial 9-pin remote cable, verify that the mouse driver being used is a Microsoft

Serial Mouse Driver. Otherwise, use the Microsoft PS/2 Mouse Driver when using the PS/2 remote cable.

Windows 3.1: In Windows Setup, the mouse driver should be set to Microsoft or IBM PS/2 mouse (when using either the
serial or PS/2 remote cable).

Macintosh: Try loading the Macintosh without any extensions loading. Verify that AppleTalk is disabled. If necessary, disable

any modems.

•

Turn off your computer and disconnect the external mouse (if applicable).

•

Connect one end of the Proxima remote cable to the computer's 9-pin serial, PS/2 or ADB port and the other end

into the CONTROL port on the projector.

•

Turn on the projector and light the lamp.

•

Turn on your computer. It should detect the projector as a mouse.

•

Use the circular mouse pad to control the mouse pointer.

If the steps above do not activate the remote mouse, follow the troubleshooting steps below:

•

Verify there are no Cyclops drivers loading. (please see next question for instructions on how to remove Cyclops
drivers)

•

Verify an external mouse works in the same port that is used for the DP5600 mouse. (Example, if using the serial

port on your PC, test the port with a 9-pin serial mouse, etc.).

•

Verify that the various functions on the remote work.(ex: Can it bring up the menus?) If not, try replacing the
batteries.

•

If unable to operate the remote mouse, power down the projector and wait one minute (leave PC/MAC powered on).

Turn the projector back on. The remote mouse should now work.

How do you find the lamp hours on the DP9200?

Push the Up-Arrow button (on keypad) for about 20 seconds. The lamp hour that is left will be displayed in the screen.

A display will appear near the top, middle of the display. Lamp hours remaining are under "Data".

Example:

Service Data

No.

Data

Mode 37

1888

Lamp "ON" time will be: 1900* - 1888 = 12 hours (* highest value when lamp hours are started or reset)

What are the scan rates for the DP9200?

•

H-Sync: 15KHz - 81KHz

•

V-Sync: 50Hz - 100Hz

Advertising