IBM RC105/IR507 User Manual
Page 10
Slim type remote control RC105/507
9
Troubleshooting：
Question Reason
Solution
If RC105
Remote
Control
doesn’t
work.
This is no battery or battery
died or un-correct battery
installation
Un-correct RC105 Remote
Control installation
Un-properly connect with
Receiver and computer.
Check battery and installation
Uninstall and re-install by
following manual “Installation
and operation third point”.
Check right connect with
receiver (USB port) and
computer (USB port)
RC105
irregular
reaction
There is not activate RC105
application
Computer software wrong
saving route for RC105
installation.
It doesn’t work after press
buttons due to the computer
software is not working
window.
Editing HotKey of installation
without closing the software
you wants to use in advanced.
Activate RC105 Remote
Control application by
following “Installation and
operation forth point”.
Modify your save route of
software by following
“Installation and operation
seventh point”.
HotKey setting is working after
activating this software by
RC105 Remote Control.
Notice:
Please activate software by RC105 Remote Control and then you can use all function
of buttons
Status：It’s doesn’t operate software by RC105 Remote Control after Plugging
IR507 receiver (with USB Port on it) into the USB port of your Sound
card or Mainboard and finishing installation.
Solution：Please re-plug IR507 receiver (with USB Port on it) with your computer or
restart your computer.