InFocus 760 - Manual (Page 20)

Connecting the LitePro 760
LitePro 760 User’s Guide 11
Connecting an IBM-Compatible Desktop Computer or SGI Starter1
Follow this procedure if your computer is an IBM-compatible
desktop computer, IBM PS/2, IBM 90/XGA, IBM 95/XGA or SGI
Starter 1.
1. Locate your monitor cable; it connects the monitor to the com-
puter. Unplug it from the computer. Remember where you
unplugged the cable from the computer, you will plug the
LitePro cable into this same connector in Step 3.
2. Attach the computer’s monitor cable to the “Monitor” end of the
LitePro cable.
3. Attach the “Computer” end of the LitePro cable to the monitor
connector on the computer.
4. Tighten the thumb screws on all the connectors to ensure proper
grounding.
5. Turn on the monitor.
6. Turn on the LitePro 760 by pressing the “1” side of the power
switch. (Refer to “Powering Up the LitePro” on page 15.)
7. Turn on the computer.
Osprey.bk Page 11 Monday, December 11, 2000 1:38 PM