IBM R31 - Manual (Page 49)

Error
Code Message Meanings Comment
0193 RF antenna had
been removed RFID antenna
has been
removed, which
was once
installed. RFID model
only.
0194 The computer is
carried through
the security
gate The computer is
carried through
the security gate
(portal gate). RFID model
only.
0197 Invalid remote
change
requested The remote
chnfiguration for
the security chip
has failed.
Confirm the
operation and try
again. System go into
BIOS Setup
automatically.
Beep Symptoms
Event Description S1/S3 Beep
POST
Diagnostic
boot End Diagnostic
boot N/A 1 short beep
Post error N/A 3 short beeps
Low battery
warning beep N/A 4 short beeps
Critical
Thermal System POST N/A 3 long beeps
DRAM type
error PC133 SDRAM
only N/A 2 long beeps
Responses of
Boot Block
BIOS Flash Success N/A 2 long, 1 short, and
then 1 long beep
BIOS file size
mismatch N/A 1 long, 1 short beep
BIOS file
reading error N/A 1 long, 2 short beeps
Floppy drive not
installed N/A 2 short beeps
Run Time /
Sleep state
BaySwap
alarm Inhibit bay swap Yes Continuous 2 short, 1
long beeps .
AC
attach/detach NO 1 short beep
Power Control
Beep System enters /
resume from
S1/S3/S4 state. N/A 1 short beep
Volume control
beep Volume key
Up/Down N/A 1 short beep
MT 2656, 2657, 2676 43