Infinity Softworks Prelude - Manual (Page 2)

3 PRELUDE MTS-STAND
2 PRELUDE MTS-STAND
Installing the Tower onto the Floor Stand
– When using the tower as a surround speaker,
set Toggle Switch in tower cup to “Full Range.”When using as
a front channel,set Toggle Switch in tower cup in bottom to
the “Full Range”position.Please consult the Prelude MTS
Subwoofer manual for exceptions to this setting.
S TEP 1 – Insert double-ended Audio Banana Plug into tower
as shown.
S
TEP
3
– Screw alignment pins into cup in bottom of tower.
Use two per tower. Screw threaded ends into holes and tighten
until snug.DO NOT overtighten.
– To add greater stability to the tower stand,add
sand (not included) in the plastic bag provided in the tower base.
Turn the base upside-down and remove the (3) 1/4-20 Phillips
screws holding the foot onto the base.
S TEP 4
– Remove one foam pad,pull out the plastic bag and open
it.Place it back into the opening of the base, taking care to fold it ove r
the sides so as to keep sand from falling into the base. Fill the plastic
b ag with sand.
S
TEP
5
S TEP 2
– Seal the plastic bag,making sure to tuck it back
inside the base and place the previously removed foam pad on
top of the sealed bag.Replace the foot with the same 1/4-20
Phillips screws.
S TEP 6
– Turn stand over and slowly lower the tower
assembly onto the stand,being careful to insert the alignment
pins into their receptacle guide holes.
S TEP 7
– Fasten the four
10-32 Socket Head Screws
through the tower base as
shown;two through the front
baffle and two in the rear slot.
Press flush into place two
screw caps to hide holes in
front-baffle base. Make sure
that the alignment slots point
toward the center to ensure that
the surface curve matches that
of the baffle.
S TEP 8