IFB Appliances AW60-9021 - Manual (Page 5)

8 7
Grounding wire
Rated voltage ~220V
Notices:
The socket and the grounding wire must be installed by an electrician to prevent
incorrect installation or use of the socket, and to guarantee the safety of use of
electricity.
The power wire of the washing machine employs Y connection and the
replacement of the power wire should be carried out by professionals.
No connection of the grounding wire with the neutral wire, otherwise the cabinet
will be charged, which is likely to cause the danger of electric shock.
SIMPLE INSTALLATION
Power source and grounding
The washing machine employs alternative current with the rated voltage 230V and
frequency 50 Hz. When the voltage fluctuates between 196V--252V, the washing machine can
work normally. A special power socket to be provided beside the washing machine for
convenience and safety. The method of connection of the socket is as the figure below:
Installation of the base cover
o 1. Slant the washing machine with angle of 45 in the direction of the arrows showed in the figure, put the
side with the clasper to the washing machine and the other side to the ground, insert back lid along the
direction of the upper slot of the base from the back side of the washing machine.
2. Put the base cover straight to the point and then press the back lid
upward till there is a sound of " Gaba" and then screw in a self-tapping screw.
Simple operation
1. Before operation, please open the s plash-free cover.
2. Put the clothes into washing tub and close the s plash-free cover.
3. Put the detergent into the water inlet case.
4. Plug the cord into the socket, switch on the power.
5. Turnon the tap connected to the two water inlet hoses.
6. Press "Power" button.
7. Press "Start/Pause" button. The washing machine will go into operation automatically as
programmed.
"Way of use". Remark: If you want to set other programs, please see and read
Hole for Self-tapping screw
Slot
Base cover
SIMPLE INSTALLATION &OPERATION