I/O Magic 16X - Manual (Page 17)

11
Driver Installation
Windows 95/98 Installation
1 Turn on your PC to start-up your Windows 95 / 98 Operating System.
Note: Refer to the troubleshooting section of this manual if your MagicDVD 16X Multi-
Purpose DVD-ROM drive is not automatically detected by Windows.
Software Installation
Power DVD Playback Software
Follow the installation instructions carefully and step by step. If you encounter a
problem, refer to the troubleshooting section on this manual.
1) Power on your computer.
2) Boot into Windows.
3) Insert the Power DVD installation CD into your CD-ROM drive.
4) The CD will automatically run and the installation program will guide you through
the entire installation process.
5) Enter the serial number when asked for it (Serial Number located on the Power
DVD CD sleeve).
6) Reboot your computer at the end of the installation.
Windows 95/98 will automatically detect the new MagicDVD 16X
Multi-Purpose DVD-ROM drive and load the appropriate drivers
for your DVD drive.
There is no need to install any device driver under Windows 95 /
98. After completing the hardware installation section of this
manual, please follow the steps below: